| | | Company | Headlines | Products | Downloads | Support | Comments | | Awards | Certificates | Employment | Search | Site Map | Home | Chapter set above: Configuration tables for HOT-419R3 Systemclock | JP22 JP21 JP23 | 20 MHz | | 25 MHz | | 25 MHz (Intel DX4, only) | | 33 MHz | | 33 MHz (Intel DX4, only) | | 40 MHz | | 50 MHz | | 50 MHz (Intel DX4, only) | | CPU voltage | JP64 | JP73 | 3.3V for Intel 3V and Cyrix 3.3V | | | 3.45V for AMD 3V | | | 4.0V for Cyrix 4V DX2 | | | 5V for all 5V CPUs | | No effect | VL-Bus Speed - JP34 | 33 MHz or more | | Below 33 MHz | | High Speed Write- JP33 | No waitstate | | 1 waitstate | | CPU DRY# Signal Delay - JP55/69 | Setup 1 for fast VL bus devices | | Setup 2 for slow VL bus devices (recommended setting) | | Address hold time (ADS#) - JP36 | Normal | | Delay ADS# signal | | HOT-419 provided two memory configuration modes, mode 1 and mode 2. Jumpers JP60, JP61, JP62, JP70, JP71, and JP72 are provided to configure the memory configuration between two memory configuration modes. In Mode 1 the mainboard supports 4 banks of socalled single density modules in sizes of 1, 4, 16 or 64MB. Mode 2 supports double density modules in sizes of 2, 8, or 32MB, too - but only 3 banks: the memory socket next to the ISA expansion slot must be left empty. The mainboard supports a total size of 2 to 128MB memory. Memory Mode 1 | Memory Mode 2 | | | Cache size | Data SRAM Bank 0 U5...U8 | Data SRAM Bank 1 U9...U12 | Tag RAM U13 | JP 10, JP13 JP50, JP11 | 64 kB | 8k x 8 | 8k x 8 | 8k x 8 | | 128 kB | 32k x 8 | empty | 32k x 8 | | 256 kB Zwei Bänke | 32k x 8 | 32k x 8 | 32k x 8 | | 256 kB Eine Bank | 64k x 8 | empty | 32k x 8 | | 512 kB | 128k x 8 | empty | 32k x 8 | | © 1999 Shuttle Inc., Last modification: 02/04/2000 All other brand and product names within this page are the property of their respective owners. Shuttle assumes no responsibility for any errors or omissions. Nor does Shuttle make any commitment to update information, with or without prior notification. |