Configuring the Disk Array (Type 86XX)

^{IBM-AUSTRIA - PC-HW-Support 30 Aug 1999}

Configuring the Disk Array (Type 86XX)

Configuring the Disk Array (Type 86XX)

The following information applies only to disk array models. Use this information to perform the tasks necessary to configure, add, change, or delete one or more disk arrays.

If you did not create an IBM RAID controller diskette, go to 'Using the CD-ROM Drive and ServerGuide'
Familiarize yourself with the information contained in this manual and the RAID (redundant array of independent disks) information in the User's Reference shipped with the server.
Verify the disk-array configuration. The disk-array model comes configured as one logical drive.
- To view the disk-array configuration, go to 'Viewing the RAID Configuration' and select View Configuration from the Main Menu.
- To create a disk array, go to 'Creating a Disk Array'
Back up the disk-array configuration. See 'Backing Up Your Disk-Array Configuration'

After you configure the disk array, you can complete setup by installing an operating system (from the ServerGuide compact disc that was shipped with the server or from the diskettes that came with the operating system). To install an operating system from the ServerGuide CD, go to 'Using the CD-ROM Drive and ServerGuide'

More INFORMATION / HELP is available at the IBM-HelpCenter

Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.