 |
IBM-AUSTRIA - PC-HW-Support 30 Aug 1999 |
Installing the SCO UnixWare Device Driver
Chapter 2. Installing the SCO UnixWare Device Driver
This chapter provides instructions for installing the SCO UnixWare device driver
(QLC2100F) under the following operating system conditions:
- Initial installation of SCO UnixWare and the QLC2100F driver
- Installation of the QLC2100F driver in an already installed SCO UNIX system
If SCO UnixWare is not installed on your system, perform the installation procedures
in 'Installing SCO UnixWare and the QLC2100F Device Driver.'
If SCO UnixWare is already installed, perform the installation procedures
in 'Installing the QLC2100F Device Driver'.
The QLC2100F driver package on the QLogic SCO UnixWare 7.0 host bus adapter (HBA)
driver diskette is provided for installation of the QLC2100F driver.
Note: This diskette cannot be read from a DOS environment.
The installation of host adapters and devices is covered in the SCO UnixWare documentation.
See the following topics for more information:
- Using boot-time loadable drivers (Installation Guide)
- Adding hard disks and CD-ROM drives (System Administrator's Guide)
More INFORMATION / HELP is available at the IBM-HelpCenter
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.