 |
IBM-AUSTRIA - PC-HW-Support 30 Aug 1999 |
Top Cover Removal
Top Cover Removal
Before you begin:
Read Safety Information.
Note:
You do not have to power-off the system to replace a
hot swap fan.
-1- Thumbscrews
-2- Top cover
To remove the server top cover:
- Turn off the server and all attached devices and
disconnect all external cables and power cords (see
Preparing to Install Options).
- Loosen the two thumbscrews -1- on the back edge of
the top cover.
- Slide the top cover -2- slightly toward the rear of the
server, the cover will stop after about 25 mm (1 inch).
Lift the cover off the server and set the cover aside.
For proper cooling and airflow, replace the top
cover before turning on the server. Operating the
server for extended periods of time (over 30
minutes) with the top cover removed might
damage server components.
Go to Server Door and Trim Bezels Removal.
Back to 
More INFORMATION / HELP is available at the IBM-HelpCenter
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.