Removing the (NetBAY3) Rear Panel

^{IBM-AUSTRIA - PC-HW-Support 30 Aug 1999}

Removing the (NetBAY3) Rear Panel

Note: Do not remove the rear panel if you are not installing a device in the NetBAY3.

Remove the NetBAY3 rear panel.
1. Remove the four screws.
2. Lift the rear panel off.
After you remove the rear panel, do one of the following:
- Install a device on rails in the NetBAY3. (Go to 'Installing Devices on Side Rails.')
- Install a cantilevered device in the NetBAY3. (Go to 'Installing Cantilevered Devices'.)
- Install a device on the NetBAY3 base plate. (Go to 'Installing Devices on the NetBAY3 Base Plate'.)

More INFORMATION / HELP is available at the IBM-HelpCenter

Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.