TDVIA BIOS Release Note

Ver 1.00 (09/26/2001) checksum:0897h
    New

Ver 1.01 (10/04/2001) checksum:6400H

    1.Disable use GPO24 to control soft off function.(dsdt.asx,chipboot.asm)
    2.Fixed Hibernate function failed under Windows 2000.
    3.Fixed HCT test 'ACPI System Test(Win 2k)' failed.(acpitbl.asm)
    4.Set Registered DIMM drive control value from 00h to 01h.(chipboot.asm)

Ver 1.02 (10/09/2001) checksum:CE95H

    1.Fixed 'poweron by PCI card' function in BIOS setup menu.(pmupost.asm)

Ver 1.10 (10/16/2001) checksum:FDB2H

    1.rename from Ver 1.02

Ver 1.11 (10/22/2001) checksum:8BD6H

    1.Change vt8633t Device 1 offset 40 from 88h to 8bh to fix DV Capture Card issue.(cfeature.asm)
    2.Fix Tualatin CPU Ratio 'x11.5','x12' function failed
    3.Fix the system crash when use Voodoo 5 VGA card in Windows NT 4.0 .- bugID:043(pcipost.asm)
    4.Fix +12v sensor value show inaccuracy.- bugID:045(sensor.ssr)
    5.Remove not used CPU micro code(Slot 1 CPU).(bios.cfg) 
    6.The Bug of BugID 57,58 not occur in this BIOS version.

Ver 1.12 (10/30/2001) checksum: 6896H

    1.Set Fan sensor Low Limit value to 2700 RPM for Intel Fan issue.(sensor.ssr)
    2.Update Promise IDE RAID Firmware from Ver1.31(build 22) to Ver1.31(build 44). 

Ver 1.20 (11/07/2001) checksum:9CA9H

    1.rename from Ver1.12

Ver 1.30 (11/20/2001) checksum:E712H

    1.Disable Onboard LAN when South Bridge is Vt8233.(chippost.asm)

Ver 1.31 (11/21/2001) checksum:3A8CH

    1.Add two new item 'Two Defer/Retry Entries','PCI Master Pineline Access' in BIOS SETUP MENU
      (Advanced->Advanced Chipset Features->CPU & PCI Bus Control).If you use Canopus DVStorm-RT
      capture Card,please enable this two funtion. (cfeature.asm)

Ver 1.32 (12/05/2001) checksum:51C7H

    1.Let DRAM run host clock when clear CMOS to fix system hang on post code C1.(chipboot.asm)
    2.Fix BIOS setup item-'Clock'->'Spread Spectrum' function.(clock.gen)
    3.Add 'Onboard RAID Boot First' function in BIOS setup item 'Advanced'->'Advanced BIOS Features'.
      (Bios.cfg)

Ver 1.33 (12/13/2001) checksum:DF15H

    1.When CPU FSB=100MHz, Let DRAM run host clock+33MHz when clear CMOS to fix system hang on 
      post code C1.(chipboot.asm)

Ver 1.40 (12/14/2001) checksum:C5E3H

    1.rename from Ver1.33

Ver 1.41 (02/20/2002) checksum:6B4BH

    1.Fixed LPT port not useful without ACPI mode.(For JEC Issue ID=#28)---superio.run

Ver 1.42 (10/15/2002) checksum:6F3BH

    1.Update Onboard RAID firmware(Ver 2.00.0.23) to support 48 bit LBA for drives larger than 137GB.