HDAMB

Installation Instructions
=========================
Flash BIOS using the following command:

phlash16 /c /bbl HDAMB091.ROM

/bbl is to flash the BIOS boot blocks
/c is to clear CMOS

If you don't add the /c parameter, you'll need to clear CMOS manually.
If you don't take off the power cord, the CMOS will not be cleared manually.


----------- Board Rev.B ----------
Ver0.27 release 06/18/2003 Checksum:051C62C8
 1. Set "Use PCI Interrupt Entries in MP Table" default to No

Ver0.28 release 06/25/2003 Checksum:051164CC
 1. Update Broadcom 5702 option rom and eeprom

Ver0.29 release 06/30/2003 Checksum:0511F01C
 1. Take off COM B
 2. Add Onboard AC97 Enable/Disable setup option

Ver0.2A release 06/30/2003 Checksum:05117FEC
 1. Fix Onboard 1394 can't disable issue

Ver0.2B release 07/08/2003 Checksum:0511AD1D
 1. Fix flash failure issue

Ver0.90 release 07/08/2003 Checksum:0511E2DF
 1. Fix Console Redirection stops working after booting into DOS
 2. fIX BIOS can't detect Slave only ATAPI devices
 3. Support C0 Stepping CPU
 4. Fix Primary Master HDD speed will drop down when low speed CDROM is connected to Primary Slave
 5. Change the speed between CPU0 and CPU1 to 1G
 6. Change the speed between CPU0 and 8151 to 800M for enhance memory bandwith and performance
 7. Support SMBIOS 2.3.3(so need to use "PHLASH16 /mode=3 /c HDAMB090.ROM" to update BIOS
 8. Add LPT,COM1 force key crisis recovery support
 9. Fix sequential prefetch feature may cause incorrect Processor operation
10. Fix CPU Errata#81 and PMM error for BIOSCHK
11. Take off COMB Redirect Console support

Ver0.91 release 07/11/2003 Checksum:05110F66
 1. Fix CPU 0 Temperature and FAN Speed display error in H/W Monitor