BIOS release 1.5 for KV8-Pro V1.0

Release information:

[ENGLISH]

1. Support CPU multiplier adjustable (for KV8-Pro v1.1 only).
2. Fixed an issue where the PS/2 wheel mouse does not respond under
   certain conditions:
  A. Using certain PS/2 wheel mice and certain USB keyboards.
  B. PS/2 wheel mouse works fine but loses response on 1st, 3rd, and 5th..
     .. time restarting windows. However, it works fine on 2nd, 4th….
     windows restart.
  C. For "PS/2 wheel mouse + PS/2 keyboard" and "USB wheel mouse + USB
     keyboard ", there no problems at all.
3. Fixed the issue that system may shutdown when CPU FAN disconnected even
   if CPU FAN SPEED monitoring disabled.
4. Synchronize with Hardware monitor value, if Voltage value changed.
5. When S3 resume CPU Clock back to pervious mode.
6. Increase CPU FSB to 336MHz.
7. Set the low limit value of CPU Voltage warning.
8. Preset AGP RATIO DEFAULT to FIXED (for KV8-Pro v1.1 only).
9. Fixed the issue that CPU multiplier unable to load default.
10. BIOS compile date: 06/16/2004


[中文]

1. 支援CPU 倍頻調整 (僅支援 KV8-Pro v1.1).
2. 修正在部分情況下PS/2滾輪滑鼠會失效的問題：
  A. 使用部分PS/2滾輪滑鼠及部分USB鍵盤。
  B. 使用正常的PS/2滾輪滑鼠但在奇數次重新開機的時候會失效，但偶數次時運作
     正常。
  C. 當使用 "PS/2滾輪滑鼠 + PS/2鍵盤keyboard" 及 " USB滾輪滑鼠 + USB鍵盤"
     時則無此問題。
3. 修正既使關閉 CPU FAN SPEED 監測後拔掉 CPU FAN接頭後會關機的問題.
4. 修正當改變 Voltage value 後未與Hardware monitor 同步的問題.
5. 自 S3 回復時 CPU Clock 回復至之前設定.
6. 增加 CPU FSB 至 336MHz.
7. 固定 CPU Voltage warning值.
8. 將 AGP RATIO 預設為 FIXED (僅支援 KV8-Pro v1.1).
9. 修正 CPU 倍頻無法設定為預設值
10. BIOS 日期: 06/16/2004


*********************************  NOTE  *********************************

1. How to upgrade BIOS:

 a. Boot into MS-DOS or "Safe mode and command prompt" if you are using
    Windows95/98
 b. Run "kv8p15.exe" to extract all files.
 c. Run "runme.bat"

   ***  Please notice that we suggest you flashing the bios with switches

           "/py /sn /cd /cp /cc /cks /R" or by "runme.bat".

 d. For more detail, please visit:

    http://fae.abit.com.tw/cht/download/bioshelp.htm  (Chinese)
    http://fae.abit.com.tw/eng/download/bioshelp.htm  (English)

2.After BIOS updated, pull off the power cord and then clear the CMOS data
  via jumper before restarting system please.


============================================================================