Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

ECA 043 - Mouse plug on 30-286



ECA 043 - Mouse plug on 30-286

 

New style Mouse requires adjustment of I/O panel

PURPOSE:
To provide a interim fix for mice that cannot be properly inserted through the I/O panel on the model 8530 286 system.

PHYSICAL check:
If difficulty is encountered while installing a Mouse inspect the diameter of the Mouse plug. If it is larger, approximately twice the size, of the keyboard plug and it is being installed on a 8530 286, this ECA applies.

DETAIL:
The new Mouse has a plug that has a larger diameter than the previous one. because of interference with the metal I/O panel, the Mouse cannot be inserted successfully. For an interim fix use the following adjustment procedure. A permanent fix is being applied during manufacturing.
  1.  Remove the rear gray plastic bezel.
  2.  Loosen the four screws that hold the I/O panel in place.
  3.  Align panel and insert the Mouse into the I/O port.
  4.  Tighten the four screws.
  5.  Remove the Mouse from the I/O port.
  6.  Install the rear gray plastic bezel
  7.  Proper installation of the Mouse is now possible.


NOTEs:
Early level mice that have a smaller plug are not eligible for this ECA:.

Back to  Jump to TOP-of-PAGE
More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.