Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

IDE - CD/DVD-ROM and ZIP-100 Drive Jumper setting



See > CD-ROM Audio Connector - Pin Layout

EMERGENCY <Option 1> CD-ROM and DVD ROM manual disk eject hint's.

If for any reasons the tray does not eject automatically then:
  1.  Make sure to turn off the PC-power
  2.  Locate the Emergency Eject hole on the DVD/CD-ROM drive:

  3.  Insert and press an eject-bar inside the emergency hole to manually eject the tray.


A straightened (formed)   paper clip with a diameter of 1.2mm (typical) can be used as an eject-bar.

EMERGENCY <Option 2> CD-ROM and DVD ROM manual disk eject hint's.

Locate the bottom edge of the disk tray. Gently pry the disk tray with a screwdriver.
When the disk tray opens, simply remove the disk from the CD-ROM drive.


 

IDE - CD/DVD-ROM and ZIP-100 Drive Jumper setting

 

CD-ROM Drive Connector Features

No. Function
1 Power Supply connector
2 Interface connector
3 Device configuration jumper
4 Audio line out connector
5 Digital audio output
6 Testing jumper is reserved for
manufacturer internal testing
purposes.


CD-ROM Drive Jumper Settings

CS SL MA Description
- - On Drive configured as a Master
- On - Drive configured as a Slave
On - - Cable select


CD-ROM, PD/CD-ROM Drive Jumper Settings

CD-ROM and PD/CD-ROM drives use jumpers or tabs to set the drives as primary (master) or secondary (slave). Refer to the drive connector labels or the figures below for the drive settings.

 

   CD-ROM, PD/CD-ROM Type
 -----------------------------------------------

   2x CD-ROM FRU P/N 06H5906  
   4x CD-ROM FRU P/N 06H7654
 -----------------------------------------------

   6x  CD-ROM                 
   8x  CD-ROM
   6x  PD/CD-ROM
  16x Max CD-ROM
  24x Max CD-ROM
  32x Max CD-ROM
 -----------------------------------------------


Aptiva 2140, 2142 CD/DVD-ROM Drive Jumper Settings


 

NOTE: For 214x models that have a factory-installed ZIP drive, the ZIP drive is jumpered as slave and the CD/DVD-ROM drive is jumpered as master.


Aptiva 2158, 2163 DVD-ROM Drive Jumper Settings


 
  1.  Power connector
  2.  IDE Interface connector (2158/63 - cable to systemboard connector CN10)
  3.  Configuration jumper (CS = Cable select, SL = Slave, MA = Master (default))
  4.  Analog Audio connector (cable to systemboard conn. 2158-CN15 / 2163-CN8)


Aptiva 2134, 2176 - Factory installed ZIP 100 ATAPI-Drive Jumper Settings


 

NOTE: The factory-installed ZIP 100 ATAPI drive is connected to the system board secondary drive connector. The ZIP drive is a direct access storage device that features removable media having a formatted capacity of 100 MB.
The ZIP Drive jumper is set as the master drive.


Aptiva 2142 - Factory installed ZIP 100 ATAPI-Drive Jumper Settings


 

NOTE: The factory-installed ZIP 100 ATAPI drive is connected to the system board secondary drive connector. The ZIP drive is a direct access storage device that features removable media having a formatted capacity of 100 MB.
The ZIP Drive jumper is set as the slave drive.
Back to  Jump to TOP-of-PAGE
More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.