|
|
|
Setting Default Value
-------------------------------------------------
Host Adapter SCSI ID 7
-------------------------------------------------
SCSI Parity Checking Enabled
-------------------------------------------------
Host Adapter SCSI Termination Enabled
AHA-2940/2940W Low On / High On
-------------------------------------------------
Reset SCSI Bus at Host Enabled
Adapter initialization
-------------------------------------------------
Host Adapter BIOS Enabled
-------------------------------------------------
Support Removable Disks Boot only
Under Bios as Fixed Disks 1
-------------------------------------------------
Extended BIOS Translation Enabled
for DOS, 1GB 1
-------------------------------------------------
BIOS Support for More Than Enabled
2 Drives 1
-------------------------------------------------
1 Settings valid only if the
adapter BIOS is enabled.
Individual Settings
The following settings are for each SCSI device connected to the adapter:
Setting Default Value
-------------------------------------------------
Initiate Sync Negotiation Yes
-------------------------------------------------
Maximum Sync Transfer Rate 10MB per second 2
-------------------------------------------------
Enable Disconnection Yes
-------------------------------------------------
Send Start Unit SCSI No
Command 1
-------------------------------------------------
Include in BIOS Scan 1 Yes
-------------------------------------------------
Initiate Wide Negotiations 3 Enabled
-------------------------------------------------
1 Settings are invalid only if the adapter
BIOS is enabled.
2 20MB per second max. synchr. transfer on
AHA-2940W.
3 AHA-2940W adapters only.
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.