|
|
|
| Error Code/Symptom | FRU/Action |
|---|---|
| 0000 | 1. Be sure the adapter Device |
| SCSI Adapter not enabled | Device and Bus Master fiels are enabled |
| in the PCI configuration program. | |
| Refer to the docomentation that was | |
| shipped with the computer. | |
| 002X | 1. SCSI Adapter |
| 008X | 1. Check SCSI terminators for proper installation |
| Check for proper installation | 2. SCSI Cable |
| of SCSI terminators | 3. SCSI Terminator |
| 4. SCSI Device | |
| 5. SCSI Adapter | |
| 0115 | 1. System Board |
| Protected mode cannot | |
| be enabled. | |
| 0164 | 1. Run Setup and ensure the memory sice |
| POST detected a base | is correct see 'Setup (BIOS Utility)' |
| memory or expansion memory | 2. Run the Expanded Memory Diagnostic tests. |
| size mismatch. | |
| 0601 | 1. Set Configuration |
| Diskette configuration error | |
| 0610 | 1. Diskette Drive |
| Cannot find diskette | 2. Diskette Drive Cable |
| controller for drive A. | 3. Diskette Drive Adapter, if installed |
| 4. System Board | |
| 0612 | 1. Diskette Drive |
| Cannot find diskette | 2. Diskette Drive Cable |
| controller for drive B. | 3. Diskette Drive Adapter, if installed |
| 4. System Board | |
| 0616 | 1. Diskette Drive Adapter |
| Diskette Drive reset failed. | |
| 0632 | 1. Diskette Drive A |
| Diskette Drive 0 seek failure. | |
| 0642 | 1. Diskette Drive B |
| Diskette Drive 1 seek failure. | |
| 0653 | 1. Format diskette |
| Diskette not formatted or defective | 2. Diskette |
| 0655 | 1. Diskette Drive |
| Diskette Drive controller failed | 2. Diskette Drive Cable |
| 3. Diskette Drive Adapter, if installed | |
| 4. System Board | |
| 107X | 1. Check SCSI Terminators for proper installation |
| Check for proper installation | 2. SCSI Cable |
| of SCSI terminators | 3. SCSI Terminator |
| 4. SCSI Device | |
| 5. SCSI Adapter | |
| 1701 | 1. Hard Disk Drive |
| Hard disk drive failed. | |
| Press F1 to restart the system. | |
| 1702 | 1. Hard Disk Drive Adapter, if installed |
| Hard disk drive controller error | 2. System Board |
| 1704 | 1. Hard Disk Drive Adapter, if installed |
| Hard disk configuration | |
| error, controller failed. | |
| 1715 | 1. Run Setup and enter the correct hard disk |
| The Hard Disk drive | drive information. |
| Configuration information is | (see 'Setup (BIOS Utility)') |
| not correct. | |
| 1726 | 1. Hard Disk Drive |
| Hard Disk drive read error | |
| Press F1 to restart the system. | |
| 182X | 1. SCSI Adapter |
| 190X | 1. SCSI Cable |
| Ensure that each SCSI device | 2. SCSI Terminator |
| is properly installed | 3. SCSI Device |
| and powered-on. | 4. SCSI Adapter |
| 1XXX | 1. SCSI Adapter |
| (not listed above) | |
| 221X | 1. SCSI Cable |
| Ensure that each SCSI device | 2. SCSI Terminator |
| is properly installed | 3. SCSI Device |
| and powered-on. | 4. SCSI Adapter |
| 222X 224X | 1. SCSI Adapter |
| 2401 | 1. Correct the Switch setting |
| The monochrome/color | 2. Display Adapter |
| switch is not set correctly | |
| 3XXX | 1. Check SCSI terminators for proper installation |
| Check for proper installation | 2. SCSI Cable |
| of SCSI terminators | 3. SCSI Terminator |
| 4. SCSI Device | |
| 5. SCSI Adapter | |
| 4XXX | 1. SCSI Cable |
| Ensure that each SCSI | 2. SCSI Terminator |
| is properly installed and | 3. SCSI Device |
| powered-on. | 4. SCSI Adapter |
| 6XXX | 1. SCSI Device |
| GP_COM | 1. System Board |
| The serial port test detected | |
| an error | |
| GP_FDU | 1. Diskette Drive |
| The diskette drive test detected | 2. System Board |
| an error | 3. Diskette Drive Cable |
| 4. Diskette | |
| GP_HDU | 1. Hard Disk Drive |
| The hard disk drive test detected | 2. Hard Disk Drive Cable |
| an error | 3. Hard Disk Drive Adapter (if installed) |
| 4. System Board | |
| GP_KBD | 1. Keyboard |
| The keyboard test detected | 2. System Board |
| an error | |
| GP_MBD | 1. System Board |
| The system board test detected | 2. Processor |
| an error | 3. Real-Time Clock Assembly |
| GP_MEM | 1. Memory Module Kit |
| The memory test detected | 2. System Board |
| an error | |
| GP_PDV | 1. Mouse |
| The mouse test failed. | 2. System Board |
| GP_PRT | 1. Printer |
| The printer test detected | 2. Printer Cable |
| an error | 3. System Board |
| GP_VID | 1. Video Adapter |
| The video test detected | 2. System Board |
| an error | 3. Color Display |
| GRPCDR | 1. CD-ROM |
| The CD-ROM test detected | 2. System Board |
| an error |
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.