FRU 73H2601 SCSI CD-ROM Info

^{IBM-AUSTRIA - PC-HW-Support 30 Aug 1999}

FRU 73H2601 SCSI CD-ROM Info

The FRU kit contains:

Instruction
White bezel assembly (2x)
Black bezel assembly (2x)
Power extender cable (used on some PC model only)
(Short power cable (60mm) female/male connector 93H2481)
PTF kit (used on some RS/6000 systems only).

NOTE: Parts of the FRU kit will not be used dependent on which type of system is being serviced.

BEZEL Installation

This information sheet supplements the information in the CD-ROM User's Guide.
To install the bezel:

Choose the color bezel to be used.
Line up the bezel piece -1- with the volume wheel on the CD-ROM Drive.
Snap all four tabs of the bezel into place. The tabs fit inside the drive frame.
Straighten one end of a paper clip to form a tool and insert it into the manual-eject hole on the front of the drive.
Push gently to release the drive tray.
The bezel piece -2- fits into the groove on the front of the drive tray.
Slide this piece downward from the top of the tray, and snap it into place.
To close the drive tray, gently push the tray in.

CD-ROM User's Guide Supplemental Information

Select the appropriate bezel and install according to the above instructions.
Make sure that the jumpers on the back of the new drive (FRU) are set to the same positions as the jumpers on the drive you are replacing.
If the drive being replaced contains a 68 pin to 50 pin adapter plug, then remove it and install it on the new drive (FRU).
When using the 68 pin to 50 pin adapter plug, there might be interference with the 4-pin power connector coming from the computer. If you encounter interference, then install the power extender cable that comes with this FRU as follows:
1. Plug one end of the power extender cable into the power cable coming from the computer.
2. Plug the other end into the power connector on the back of the drive.
3. Because of the design of the connectors, the power extender cable will fit only one way. If it does not fit, turn it and try again.

NOTE For more information about the cable connections, see the documentation which came with the original CD-ROM Drive.

Back to

More INFORMATION / HELP is available at the IBM-HelpCenter

Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.