Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

Removing the Top Cover (Netfinity 7000-M10 - Type 8680)



Removing the Top Cover: Refer to the following illustration while you perform the steps in this procedure.

Before you begin: Read 'Safety Information'.
 

To remove the server top cover:
  1.  Except if you are installing or removing a hot-swap option, run the shutdown  procedure for the operating system, turn off the server and all attached devices,  and disconnect all external cables and power cords (see 'Preparing to Install Options').
  2.  Loosen the two thumbscrews -1- on the back edge of the top cover.
  3.  Slide the top cover -2- slightly toward the rear of the server,  the cover will stop after about 25 mm (1 inch).
     Lift the cover off the server and set the cover aside.

More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.