Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

ESM Board Replacement (Netfinity EXP15 - 3520)



ESM Board Replacement
 

To remove the ESM board:
  1.  Shut down the expansion unit. For shutdown information, see 'Performing a Shutdown'
  2.  Grasp each pull-ring and squeeze the latches to release.
  3.  Pull open both levers at the same time and remove ESM board.


NOTE:

When inserting the ESM board:
  1.  Make sure both levers are straight out, as shown above.
  2.  Using your hand, gently push on the center of the ESM board to insert it into the controller.
  3.  When inserting the ESM board, make sure both levers swing inward at the same time.
  4.  Close and lock both levers at the same time.

More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.