 |
IBM-AUSTRIA - PC-HW-Support 30 Aug 1999 |
The Identify Function
Identify Function
The Identify function can be accessed from most of the SSA Configurator and Service Aids Utility displays.
This function enables you to determine the location of a particular disk drive that you want to identify, but do not
want to remove. Identify causes the Check light of the disk drive to flash for identification (two seconds on, two seconds off), but has no
effect on the normal operation of the disk drive. It also causes the Check light (if present) of the unit containing the selected
disk drive to flash. You can use the Identify function on any number of disk drives at the same time.
Instructions displayed by the service aids tell you when you can select the Identify function.
The service aids display the UIDs of the devices. By checking the UID on the serial-number label on the device, you can verify that
the correct device has its Check light flashing.
To start the Identify function, press F9 (FlashOn). To end the Identify function, press F10 (FlashOff).
More INFORMATION / HELP is available at the IBM-HelpCenter
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.