|
|
|
| No Beep/Symptom | FRU/Action |
|---|---|
| No beep and the system | 1. Check speaker cables |
| operates correctly. | 2. Speaker |
| 3. System Board | |
| No Beeps occur after | 1. Run Configuration/Setup, set the Start Options |
| successfully completing | Power-On Status to enable. |
| POST | 2. Check speaker connection. |
| (The Power-On Status is | 3. Speaker |
| disabled.) | 4. System Board |
| No AC power | 1. Check the power cord |
| (Power supply AC LED is | 2. Power Supply (If two are installed, swap |
| off) | them to determine if one is defective.) |
| 3. Power Backplane | |
| 4. Hot Swap Power AC Inlet Box | |
| No beep and no video | 1. See 'Undetermined Problems' |
| System will not power-up | 1. See 'Power Supply LED Errors.' |
| (Power supply AC LED is | |
| on) |
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.