|
|
|
| Item | Description |
|---|---|
| Dial-in enabled | Check this check box to enable remote users to dial |
| into and access the Advanced Systems Management | |
| Adapter. If this box is unchecked, remote users will | |
| be unable to remotely access the Advanced Systems | |
| Management Adapter. Click on Apply after checking | |
| or unchecking this check box to save the new setting. | |
| Dialout retry | Use the spin buttons to select the number of additional |
| limit | times that the Service Processor Manager will attempt |
| to forward the alert. | |
| Dialout retry | Use the spin buttons to specify the number of seconds |
| delay | that the Service Processor Manager will wait before |
| retrying a dialout attempt. | |
| Own port when | Check this check box to reserve a serial port for |
| startup | exclusive use by the Advanced Systems Management |
| Adapter. If the Advanced Systems Management | |
| Adapter is built into your system, checking this box will | |
| reserve one of your system's serial ports. If the | |
| Advanced Systems Management Adapter is an | |
| adapter, checking this box will reserve one of the | |
| adapter's integrated communications ports. Click on | |
| Apply after checking or unchecking this check box to | |
| save the new setting. | |
| Note: This checkbox should be checked if you are | |
| configuring your system for dial-in access. If | |
| this checkbox is not checked, you will be | |
| unable to dial-in to this system unless the | |
| Advanced Systems Management Adapter has | |
| reclaimed the port for a dialout. If you want to | |
| configure the Advanced Systems Management | |
| Adapter to always be dial-in enabled, | |
| regardless of whether the system is currently | |
| powered up, you must check this check box. | |
| When this check box is checked, you cannot | |
| configure the specified port for use by your | |
| system. | |
| Dialout number | If you have configured more than one Dialout Entry to |
| spacing | forward alerts, the Advanced Systems Management |
| Adapter will attempt to contact each of these entries | |
| sequentially. Use the spin buttons to specify the | |
| number of seconds for the Advanced Systems | |
| Management Adapter to wait between dialout attempts | |
| for separate Dialout Entries. | |
| Dial-in delay | The Dial-in delay (minutes) field shows the number |
| (minutes) | of minutes that must pass after an incorrect User ID or |
| Password has been used in 5 successive dial-in | |
| attempts to the Advanced Systems Management | |
| Adapter, before valid dial-in access will be permitted. | |
| After the fifth successive login failure dial-in access is | |
| disabled for the number of minutes you specify, the | |
| Advanced Systems Management Adapter adds an | |
| entry in the Event Log noting that dial-in access was | |
| suspended due to 5 successive login failures, and the | |
| Advanced Systems Management Adapter will attempt | |
| to forward an alert if the Tamper Enabled Alerts | |
| Dialout checkbox has been checked. |
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.