Hot Swap Tray / 3518

^{IBM-AUSTRIA - PC-HW-Support 30 Aug 1999}

Hot Swap Tray / 3518

Hot Swap Tray FRU P/N 06H8631, 07H0774 (Type 3518)

Note:

The following trays are shown with drives installed.
Each hot-swap drive installed must have a Hot Swap Drive Tray attached.

The Hot Swap Drive Tray for the expansion enclosure has a small switch that stops the movement of the disk drive. The tray also provides two LEDs (one green and one amber) to indicate the current state of the drive and tray. The following table summarizes the LED states on the hot-swap tray and their meanings.

The drive is defective, or no power is being supplied to the drive. The hot-swap drive can be removed safely. :etable. More INFORMATION / HELP is available at the IBM-HelpCenter Please see the LEGAL - Trademark notice. Feel free - send a for any BUG on this page found - Thank you. Green Amber Description On Off The Drive tray is powered on, the hard disk drive is inactive, and the drive should not be removed. Blinking Off The hard disk drive is inactive. The hot-swap drive can be removed safely. On On or Blinking The hard disk drive is in use, and should not be removed. Off Off

Green	Amber	Description
On	Off	The Drive tray is powered on, the hard disk drive is inactive, and the drive should not be removed.
Blinking	Off	The hard disk drive is inactive. The hot-swap drive can be removed safely.
On	On or Blinking	The hard disk drive is in use, and should not be removed.
Off	Off