Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

Single Latch Rail Tray (9306)



Single Latch Rail Tray

To remove a sliding tray with single latch rails:
  1.  Power-off the rack.
  2.  Open the rear door of the rack cabinet and remove the pin 1 that secures the sliding tray to the cable management arm
  3.  Loosen the thumbscrews 2 on the sliding tray and  fully extend the sliding tray.
  4.  Use a 3/32-inch allen wrench to remove the five screws 3  from the left side of the sliding tray.
  5.  Lift the rear locking tab 4 and push the sliding  tray approximately two inches into the cabinet.
  6.  Release the forward locking tab 5.  Then, while holding the sliding tray in place,  use your other hand to grasp the outside sliding  rail 6 and push it into the rack cabinet until it disconnects  from the sliding tray.


Graphic showing rear of cabinet and pin removal

 

More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.