 |
IBM-AUSTRIA - PC-HW-Support 30 Aug 1999 |
Power Supplies (Hot Swap) (Netfinity EXP10 - 3520)
Power Supplies (Hot Swap)
To remove a power supply:
- Turn the switch on the power supply to the Off position.
- Unplug the supply power cord from the electrical outlet.
- Disconnect the power cord from the power supply.
- Grasp ring and squeeze to unlatch.
- Pull open lever and remove power supply.
NOTE: When installing a new power supply, make sure
that the latch is mounted to the side of the supply that is toward the middle
of the machine. If not, remove the lever screw, flip the lever over and
replace the screw. See the illustration above.
More INFORMATION / HELP is available at the IBM-HelpCenter
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.