IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

Removing the Power-on Password when Keylock is Installed

•  Read Safety Information
•  Power-off the server
•  Disconnect all external cables and power cords, and then remove the server cover

1.  Locate the Clear CMOS jumper (J23, pin 7)
2.  Verify that the keylock is connected to the system board. If no keylock  is installed, go to 'Removing the Power-On Password When Keylock is Not Installed'.
3.  Add a jumper to pins 2 and 3 (the pins furthest away from the microprocessor board).
4.  Replace the server cover and reconnect all external cables and power cords.
5.  Power-on the server, then, close and lock the server door.
6.  Power-off the server, and remove the cables.
7.  Remove the jumper from jumper J23-7, if you moved the jumper earlier, replace it in its original position.
8.  Replace the server cover and reconnect all external cables and power cords.
9.  Power-on the server and use the Configuration/Setup utility programs to enter a new password and reconfigure the server.

   NOTE: The administrator password is not affected by this jumper.

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.