|
|
|
| Symptom/Error | FRU/Action in Sequence |
|---|---|
| Unable to communicate using | 1. Make sure the setup for the IR is correct. |
| the Infrared (IR) Port. | Use the WorkPad z50 Configuration utility. |
| 2. Make sure there are no fluorescent lights near the | |
| WorkPad z50. The WorkPad z50 may receive optical | |
| noise from the fluorescent light. | |
| 3. Run the advanced diagnostic test. If an error | |
| occurs, replace the parts shown by the FRU code. |
Note: If you cannot find a symptom or an error in this list and the problem remains,
see 'Undetermined Problems'.
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.