 |
IBM-AUSTRIA - PC-HW-Support 30 Aug 1999 |
Checking the Battery Pack (2600-310/310D/310E/310ED)
Checking the Battery Pack
Do the following:
- Power off the computer.
- Remove the battery pack and measure the voltage between battery
terminals 1 (+) and 6 (-).
| Terminal |
Voltage (Vdc) / Signal |
| 1 |
+0 to +13 |
| 2 |
ID |
| 3 |
Thermal |
| 4 |
Data |
| 5 |
Reserved |
| 6 |
Ground |
NOTE: Signal lines, not used in these steps, are used for communication
between the system and the battery.
- If the voltage is less than +11Vdc, the battery pack has been discharged.
Recharge the battery pack.
If the voltage is still less than +11Vdc after recharging, replace the battery.
NOTE: If the voltage of the battery pack is 0V, it might be not defective.
More INFORMATION / HELP is available at the IBM-HelpCenter
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.