PCI600F

• Slot 1 for Intel Pentium II & III and Celeron
• Intel 82440BX Chipset.
• SMC FDC37M602 Power Multi I/O Chip.
• Dimensions: 30.5cm x 21.5cm (12 inches x 8.5 inches) ATX form.
• Award PnP PCI flash BIOS.
• Four 168-pin DIMM sockets.
• Two Enchance IDE sockets (up to four IDE devices) support fast ATA-2, ATAPI, and Ultra DMA/33 functions.
• One Floppy socket supports two floppy drivers with 360K, 720K, 1.22M, 1.44M, and 2.88M bytes.
• One AGP slot supports x1and x2 AGP card.
• Four PCI slots. (PCI spec. V2.1)
• Three ISA slots. (1 PCI/ISA shared slot)
• PS/2 keyboard and PS/2 mouse connectors on board.
• Two Serial Port sockets.
• One Parallel Port socket supports SPP, EPP, and ECP.
• Two USB Port connectors on board.
• One FIR (Fast IrDA) Port connector on board (transfer rate up to 4MB/s).
• System hardware health monitor.
• (Optional) Adaptec AIC-7880 Ultra Wide SCSI controller.
• (New) Modem wake-up function to switch system power on.
• (New) LAN wake-up function.
• (New) Automatic frequency reduction in case of CPU overheating.

1. CPU Jumper Settings

* BIOS automatically detects CPU system speed.

Note:

• ON - jumper block short
• NC- jumper block open

2. Clear CMOS Data Jumper Settings

3. Support DIMM Module List

• Each DIMM socket supports 4M to128M bytes (for 16Mbit technology) or 8M to256M bytes (for 64Mbit technology) DIMM module.
• Vcc provides 3.3v
• Support SDRAM-II, SDRAM and EDO DIMM modules.

4. Support Year 2000 Compliance

• BIOS version 1.00 or later supports Year 2000 compliance.

5. Support LS-120 Zip Driver Boot Function

6. Support SCSI/CD-ROM Function

7. Support INT 13 Expansion Mode (control above 8.4 GB IDE Hard Disk)